1PK Toggle Clamp, 200 lbs Holding Capacity, 12050 Quick Release Vertical Clamps w/ Antislip Rubber Pressure Tip for Woodworking Jigs and Fixtures, Welding, Drill Press, Crosscut Sled (20303)

Ordered these for a tool I was building - to hold a template and workpiece. Then used a trim router to complete the workpiece. the hold downs were smaller than I envisioned, but worked well. Four clamps held a on a stack of a 1/2 plywood template and corresponding workpiece securely, with easy out for the next piece.

Ordered a few of these for jigs for my table saw. Clamps work fine but there are two things to note. First, they do not come with any mounting screws. Not a huge deal but it is annoying. Second, there is not much range in how big of things you can clamp. For instance, I have my jig set up to clamp 1x boards but I cannot clamp 2x boards using the same jig. I would need to create a second jig or buy different clamps.

This is a nifty thing to have. I guess most people use these as some sort of vice or work holder but I bought two to use as a door latch for a metal shed door that was always slipping open a bit. I attached them to the door so that when the door is closed this toggle pulls the door back against the top wall and secures the door tight. It is adjustable so that the rubber stop and bar can be moved further or closer to the piece it is attached against. These things are well made and look like they should last forever. They work great and I highly recommend. Hope this helps.

Very useful size that allows installation where other toggle clamps are just too big. The clamp screw could be longer. Single hole for the pressure screw on my units. The fastening nuts are very soft and strip-out easily. I have to give 5 stars though because they fit my application perfectly. Other nuts are easy to come by. A clamp that would fit my space requirements was not.

Good quality item just a bit smaller than I expected

Mine came missing the "tabs" that fit on the bolt and help prevent the nuts from loosening. I am not going through the hassle of sending it back, but this says something about their quality control. This clamp is on the small side. In hindsight, I should have spent $3 more and gotten this one: http://www.amazon.com/POWERTEC-20305-Vertical-Quick-Release-500-Pound/dp/B004K5WWPW/ref=sr_1_5?s=hi&ie=UTF8&qid=1408035070&sr=1-5&keywords=toggle+clamp+vertical

Used this to make a emergency brake on my Honda pioneer 1000. Works great

didn't come with any hardware for installation. thought that was pretty cheap. clamp failure/breakage on first attempt on a 1/2 piece of plywood. would not recommend for anything other than a novelty to use for paper on desk/wall...maybe would be nice to hang a calendar. otherwise cheap useless garbage.